NetBSD 2.0.3_STABLE (KLOSTER) #1: Sun Nov 27 14:21:07 EST 2005 jschauma@doppelbock.hpcf.cs.stevens-tech.edu:/usr/2.0/src/sys/arch/i386/compile/obj/KLOSTER total memory = 1023 MB avail memory = 997 MB BIOS32 rev. 0 found at 0xfd6a0 mainbus0 (root) mainbus0: Intel MP Specification (Version 1.4) (TYAN GUINNESS ) cpu0 at mainbus0: apid 1 (boot processor) cpu0: AMD Athlon (686-class), 1526.61 MHz, id 0x662 cpu0: features c3cbfbff cpu0: features c3cbfbff cpu0: features c3cbfbff cpu0: I-cache 64 KB 64B/line 2-way, D-cache 64 KB 64B/line 2-way cpu0: L2 cache 256 KB 64B/line 16-way cpu0: ITLB 16 4 KB entries fully associative, 8 4 MB entries fully associative cpu0: DTLB 32 4 KB entries fully associative, 8 4 MB entries 4-way cpu0: calibrating local timer cpu0: apic clock running at 265 MHz cpu0: 8 page colors cpu1 at mainbus0: apid 0 (application processor) cpu1: starting cpu1: AMD Athlon (686-class), 1526.54 MHz, id 0x662 cpu1: features c3cbfbff cpu1: features c3cbfbff cpu1: features c3cbfbff cpu1: I-cache 64 KB 64B/line 2-way, D-cache 64 KB 64B/line 2-way cpu1: L2 cache 256 KB 64B/line 16-way cpu1: ITLB 16 4 KB entries fully associative, 8 4 MB entries fully associative cpu1: DTLB 32 4 KB entries fully associative, 8 4 MB entries 4-way mpbios: bus 0 is type PCI mpbios: bus 1 is type PCI mpbios: bus 2 is type ISA ioapic0 at mainbus0 apid 2 (I/O APIC) ioapic0: pa 0xfec00000, version 11, 24 pins pci0 at mainbus0 bus 0: configuration mode 1 pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok pchb0 at pci0 dev 0 function 0 pchb0: Advanced Micro Devices AMD762 NorthBridge (rev. 0x11) agp at pchb0 not configured ppb0 at pci0 dev 1 function 0: Advanced Micro Devices AMD762 AGP Bridge (rev. 0x00) pci1 at ppb0 bus 1 pci1: i/o space, memory space enabled pcib0 at pci0 dev 7 function 0 pcib0: Advanced Micro Devices AMD766 SouthBridge (rev. 0x02) pciide0 at pci0 dev 7 function 1 pciide0: Advanced Micro Devices AMD766 IDE controller (rev. 0x01) pciide0: bus-master DMA support present, but unused (no driver support) pciide0: primary channel configured to native-PCI mode pci_intr_map: no mapping for pin A (line=ff) pciide0: couldn't map native-PCI interrupt pciide0: secondary channel configured to compatibility mode pciide0: secondary channel interrupting at ioapic0 pin 15 (irq 15) atabus0 at pciide0 channel 1 Advanced Micro Devices AMD766 Power Management Controller (miscellaneous bridge, revision 0x01) at pci0 dev 7 function 3 not configured wm0 at pci0 dev 8 function 0: Intel i82544EI 1000BASE-T Ethernet, rev. 2 wm0: interrupting at ioapic0 pin 16 (irq 10) wm0: 64-bit 33MHz PCI bus wm0: 64 word (6 address bits) MicroWire EEPROM wm0: Ethernet address 00:02:b3:d6:3d:25 makphy0 at wm0 phy 1: Marvell 88E1000 Gigabit PHY, rev. 0 makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto wm1 at pci0 dev 9 function 0: Intel i82543GC 1000BASE-X Ethernet, rev. 2 wm1: interrupting at ioapic0 pin 17 (irq 14) wm1: 64-bit 33MHz PCI bus wm1: 64 word (6 address bits) MicroWire EEPROM wm1: Ethernet address 00:03:47:0d:3a:05 wm1: 1000baseSX, 1000baseSX-FDX, auto twe0 at pci0 dev 10 function 0: 3ware Escalade twe0: interrupting at ioapic0 pin 18 (irq 5) twe0: 2 ports, Firmware FE7X 1.05.00.034, BIOS BE7X 1.08.00.038 twe0: Monitor ME7X 1.01.00.035, PCB Rev3 , Achip V3.20 , Pchip V1.30 twe0: port 0: WDC WD400JB-00ENA0 38166 MB twe0: port 1: WDC WD400JB-00ENA0 38166 MB ld0 at twe0 unit 0: TwinStor, status: Normal ld0: 38165 MB, 9692 cyl, 128 head, 63 sec, 512 bytes/sect x 78163312 sectors twe1 at pci0 dev 12 function 0: 3ware Escalade twe1: interrupting at ioapic0 pin 16 (irq 10) twe1: 4 ports, Firmware FE8S 1.05.00.068, BIOS BE7X 1.08.00.048 twe1: Monitor ME7X 1.01.00.040, PCB Rev5 , Achip 3.20 , Pchip 1.30-66 twe1: port 0: WDC WD2500JD-50GBB0 238475 MB twe1: port 1: WDC WD2500JD-50GBB0 238475 MB twe1: port 2: WDC WD2500JD-50GBB0 238475 MB twe1: port 3: WDC WD2500JD-50GBB0 238475 MB ld1 at twe1 unit 0: 64K stripe RAID5, status: Normal ld1: 698 GB, 91203 cyl, 255 head, 63 sec, 512 bytes/sect x 1465185024 sectors ATI Technologies Rage XL (VGA display, revision 0x27) at pci0 dev 14 function 0 not configured ex0 at pci0 dev 15 function 0: 3Com 3c980C-TXM 10/100 Ethernet (rev. 0x78) ex0: interrupting at ioapic0 pin 18 (irq 5) ex0: MAC address 00:e0:81:04:a3:e5 exphy0 at ex0 phy 24: 3Com internal media interface exphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto ex1 at pci0 dev 16 function 0: 3Com 3c980C-TXM 10/100 Ethernet (rev. 0x78) ex1: interrupting at ioapic0 pin 19 (irq 11) ex1: MAC address 00:e0:81:04:a3:e6 exphy1 at ex1 phy 24: 3Com internal media interface exphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto isa0 at pcib0 com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, working fifo com0: console com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, working fifo pcppi0 at isa0 port 0x61 sysbeep0 at pcppi0 npx0 at isa0 port 0xf0-0xff: using exception 16 ioapic0: enabling atapibus at pciide0 not configured boot device: ld0 root on ld0a dumps on ld0b root file system type: ffs cpu1: CPU 0 running